Double end studs are common in flange joints and equipment mounting: one end screws into the body, the other takes a nut, so disassembly never damages the base thread. The usual confusion in purchasing is treating GB/T 898, DIN 938 and DIN 939 as interchangeable. They look alike, but the driven end thread length differs, and a wrong choice bottoms out or barely engages.
The Chinese series splits studs by driven end thread length bm: GB/T 897 at 1d, GB/T 898 at 1.25d, GB/T 899 at 1.5d, GB/T 900 at 2d. In the German system DIN 938 is roughly 1d and DIN 939 roughly 1.25d. So GB/T 897 sits closest to DIN 938 and GB/T 898 to DIN 939. Length is defined differently too: state whether a figure is overall length or excludes the bm end.
The thread in the body must develop tensile and shear capacity at least equal to the stud, or the internal thread fails first. Practice is 1d for steel, 1.25d for cast iron, 1.5d for aluminium, 2d for soft alloys. Blind holes need runout allowance, two to three pitches deeper than bm, or the stud bottoms and tightening is false.
General machinery uses class 8.8 or 10.9 carbon steel. Chemical and pressure flanges often follow ASTM A193 B7 or B7M, the latter with a hardness ceiling for wet H2S service. Stainless 304 and 316 dominate, 316 in chloride exposure. Class 10.9 and above that is electroplated must be baked to avoid delayed fracture.
Check both thread ends, since custom studs may differ; thread accuracy with go and no-go gauges, 6g for external thread; straightness, because a bent stud loads eccentrically; and chamfer with marking. Typical failures are threaded rod used instead of studs, a 1d bm in a cast iron body, and length quoted against a different datum. Zhuhai Jiali Hardware (FASTKING) produces to GB/T 897 to 900 and DIN 938, DIN 939 with material certificates. See the screw calculator directory or contact us.