The most common defect on a cold heading line is cracking: star cracks on the head, longitudinal splits on the shank, or a part breaking in two at upsetting. The first reaction is to adjust the machine and the lubricant, but a crack running along grain boundaries with a woody fracture points to the wire rod, not the die.
Centre cracks on the head suggest surface defects or an excessive upset ratio. Transverse cracks at the fillet mean too small a die radius or concentrated deformation. Longitudinal shank splits point to centre porosity, stringer inclusions or subsurface blowholes, while ring cracks at the head edge follow excessive hardness. Record location, crack direction and heat number: one heat failing at one station identifies the material, intermittent failures across heats suggest a narrow window.
Chemistry and segregation come first: high carbon or manganese raises flow stress, while excess sulphur and phosphorus form low melting inclusions. Second, non-metallic inclusions rated to GB/T 10561, where elongated alumina and silicate stringers act like pre-set cracks. Third, surface defects such as scratches, laps and scabs, plus blowholes exposed where deformation is severe.
Spheroidise annealing quality sets cold formability. Under annealing leaves lamellar carbide, raising hardness and cutting ductility; over annealing coarsens grains. Judge by microstructure and hardness together. Phosphate coating and soap carry the lubricant, and a thin film breaks down in high deformation zones, causing pickup and cracking. Excessive drawing reduction also consumes the ductility reserve.
Check process first, then material: die radius and clearance, lubrication, upset ratio and station allocation. If process is excluded, test the heat for chemistry, inclusions and microstructure. A woody fracture with little plastic flow indicates material; shear lips indicate process. Send location, heat number and photographs to the mill.
Cracking is never one cause. Zhuhai Jiali Hardware (FASTKING) traces heading, thread rolling and heat treatment by lot and supplies mill certificates and test reports. See the screw calculator directory or contact us.