Two bolts of the same size and grade, one rolled between flat dies and one turned on a lathe, may carry nearly the same static load yet differ several times over in fatigue life. The difference lies not in dimensions but in the metal at the thread root.
Thread rolling is chipless. The blank is squeezed between dies, grains elongate into a continuous flow line that is never cut. Turning removes material, so each pass severs the flow line and leaves the root as a machined surface across the grain. Fatigue cracks start where the flow line is interrupted, which explains most of the life gap.
Fatigue strength depends on the root notch. A rolled root is a smooth radius formed by the die crest, so it stays consistent; a turned root follows tool shape and feed, often ends tighter than the drawing, with tool marks. Every mark is a micro notch and a potential crack origin.
Rolling cold works the root surface, raising hardness above the core and leaving compressive residual stress. Turning leaves tensile residual stress plus a slight tempering effect from cutting heat, weakening the surface layer.
Both types crack at the root of the first loaded thread, yet a metallographic section separates them clearly: rolled grains sweep around the root while turned grains stop dead at it. That section is the clearest evidence.
High volume and fatigue critical joints default to rolling. High strength bolts are rolled before quenching and tempering, since rolling afterwards promotes delayed fracture. Turning suits large, non standard or thin wall parts and repair work, where a generous root radius recovers part of the loss.
Go gauges and tensile tests reveal none of this. Fatigue testing, root metallography and a hardness gradient are needed, and the route should state whether rolling precedes or follows heat treatment. Zhuhai Jiali Hardware (FASTKING) controls that sequence and supplies metallographic and hardness reports. See the screw calculator directory or contact us.